Kyocera Mita S-9100DN Operation Manual page 54

6
Press the ENTER key. Processing appears, then
Waiting.
7
In this state, send the file from the computer to the
printer.
The file is written onto the memory card given a
destination name (also referred to as a partition name)
which the printer automatically assigns one after
another as follows:
DataS001 (first data),
DataS002 (second data),
DataS003 (third data)...
In the example above, if the file TEST.TXT is the first
data to be written onto the memory card, the
destination name will be DataS001.
As the printer receives data, the message display
changes to Processing, then when the end of the
data is received, the message display changes to
Waiting.
8
Check that the message display has changed to
Waiting, then press the GO key. This writes the file to
the memory card and instructs the printer to automati-
cally print out a memory card write information page as
shown below.
WRITE INFORMATION
Partition Type:
Partition Name:
Write Partition Length: The size of the written data on
Others:
When the memory card write information page is print-
ed, the message display returns to Ready.
If the writing is not completed successfully, an error
code appears on the message display. For details, see
Error Messages on page
GO key. The message display returns to Ready.
FS-9500DN Page Printer
Type of data written (currently
only type 2 is supported).
The destination name of data
written to the card.
the memory card.
Error information.
4-6. If this happens, press the
Chapter 3 Using the Operator Panel
9 Repeat above steps until you have transferred all data
(files) that you want to write to the memory card. Each
time you finish writing data, a memory card write informa-
tion page is printed from the printer showing the informa-
tion explained in step 8 above, but pertaining only to the
data just written. To see all data contained in the memory
card at once, print a list of data names as explained. See
Printing a List of Data Names on page
Deleting Data
It is possible to use the printer to delete data from a memory card
one by one.
To delete data from a memory card, proceed as follows. Check
that the memory card contains data. Otherwise, the >Delete
Data menu will not appear on the message display.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Memory Card >
appears.
Memory Card
3 Press the 2 key.
4 Press the 3 or 4 key repeatedly until >Delete Data
appears. The data name also appears.
>Delete Data
DataS001
5
Press the ENTER key. A blinking question mark (?) ap-
pears before the data name.
>Delete Data
?DataS001
6 Press the 3 or 4 key to display the desired data name.
7
Press the ENTER key. Processing appears and the
data is deleted from the memory card. The display re-
turns to Ready.
Formatting
Formatting allows data to be written to the card. A new memory
card must be formatted before it can be used in the printer.
Formatting deletes any existing data on the memory card.
To format a memory card, proceed as follows.
1
Press the MENU key.
3-39.
>
3-38