Kyocera Mita S-9100DN Operation Manual page 53

Chapter 3 Using the Operator Panel
Reading Font Data
If a memory card with the font data is already inserted into the
slot when the printer is turned on, the fonts are automatically
read into the printer. To re-read fonts into the printer from a
memory card, proceed as follows.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Memory Card >
appears.
Memory Card
3
Press the 2 key.
4
Press the 3 or 4 key repeatedly until >Read Fonts
appears.
>Read Fonts
5
Press the ENTER key. A question mark (?) appears.
>Read Fonts
6
Press the ENTER key. Processing appears and the
reading of data from the memory card starts.
>Read Fonts
Processing
7
Press the MENU key to return to Ready.
Reading Data
Data stored on a memory card can be read. To read data on a
memory card, proceed as follows.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Memory Card >
appears.
Memory Card
3 Press the 2 key.
3-37
>
?
>
4
Press the 3 or 4 key repeatedly until >Read Data
appears. The data name also appears.
>Read Data
DataS001
5
Press the ENTER key. A blinking question mark (?) ap-
pears before the data name.
>Read Data
?DataS001
6
Press the 3 or 4 key to display the desired data name.
7
Press the ENTER key. Processing appears and the
reading of data from the memory card starts.
Writing Data
Data can be written to a memory card until no space is left for
storing. When writing to a memory card, a name is assigned to
the file automatically. You can use the procedure explained later
in this section to print a list of data names for confirmation.
To write data to a memory card, proceed as follows.
First check that the memory card is properly formatted. Other-
wise, the >Write Data message to be explained below will not
be shown on the message display.
If the memory card inserted in the memory card slot is not for-
matted, the >Format will automatically appear on the display.
See Formatting on page 3-38.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Memory Card >
appears.
Memory Card
3
Press the 2 key.
4
Press the 3 or 4 key repeatedly until >Write Data
appears.
>Write Data
5
Press the ENTER key. A question mark (?) appears.
>Write Data ?
>