Kyocera Mita S-9100DN Operation Manual page 41

Chapter 3 Using the Operator Panel
Q Q Q Q Changing Type for Courier/Letter Gothic
Courier or Letter Gothic font type can be selected as Regular or
Dark. For example, to change the type of Courier, proceed as
follows:
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Font > appears.
Font
3 Press the 2 key.
4 Check that Internal is displayed and press the 2
key.
>Font Select
Internal
5 Press the 3 or 4 key repeatedly until >Courier ap-
pears.
>>Courier
Regular
6
Press the ENTER key. A blinking question mark (?) ap-
pears.
>>Courier
? Regular
7
Select Regular or Dark using the 3 or 4 key.
8
Press the ENTER key.
9
Press the MENU key and the message display returns
to Ready.
Q Q Q Q Changing the Font Size
You can change the size of the default font. If the default font is
a fixed-pitch font such as Courier or Letter Gothic, the character
pitch can be changed instead of the font size.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Font > appears.
Font
3-25
>
>
>
3
Press the 2 key.
4
Check that Internal is displayed and press the 2
key.
>Font Select
Internal
5 Press the 3 or 4 key repeatedly until >Size appears.
>Size
012.00 point(s)
6
Press the ENTER key. A blinking cursor ( _ ) appears.
>Size
012.00 point(s)
7
Press the 3 or 4 key to increase or decrease the value
of the figure where the cursor is blinking. The font size
can be set between 4 and 999.75 points, in 0.25-point
increments. You can use the 2 and 1 key to move the
cursor right and left.
8
When the desired size is displayed, press the ENTER
key.
9
Press the MENU key. The message display returns to
Ready.
Q Q Q Q Setting the Character Pitch for Courier/Letter Gothic
You can set the character pitch for fixed-pitch fonts when the de-
fault font is Courier or Letter Gothic.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Font > appears.
Font
3
Press the 2 key.
4
Check that Internal is displayed and press the 2
key.
>Font Select
Internal
>
>
>