Dell PowerEdge T310 Hardware Owner's Manual page 47

Table 1-3. System Messages (continued)
Message
Quad rank DIMM
detected after
single rank or
dual rank DIMM in
socket.
Read fault
Requested sector
not found
SATA Portx
device not found
SATA port x
device
auto-sensing
error
SATA port x
device
configuration
error
SATA port x
device error
Downloaded from www.Manualslib.com
Causes
Invalid memory
configuration.
The operating system cannot
read from the hard drive,
optical drive, or USB device,
the system could not find a
particular sector on the disk,
or the requested sector is
defective.
There is no device connected
to the specified SATA port.
The drive connected to the
specified SATA port is faulty.
manuals search engine
Corrective Actions
Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 108.
Replace the optical medium,
USB medium or device.
Ensure that the
SAS backplane, USB,
or SATA cables are
properly connected.
See "Troubleshooting a USB
Device" on page 148,
"Troubleshooting an Optical
Drive" on page 158,
or "Troubleshooting a Hard
Drive" on page 160 for the
appropriate drive(s) installed
in your system.
Information only.
Replace the faulty drive.
About Your System
47