Dell PowerEdge T310 Hardware Owner's Manual page 46

Table 1-3. System Messages (continued)
Message
No boot sector on
hard drive
No timer tick
interrupt
PCI BIOS failed
to install
PCIe Training
Error: Expected
Link Width is x,
Actual Link Width
is y.
Plug & Play
Configuration
Error
46
Downloaded from www.Manualslib.com
Causes
Incorrect configuration
settings in System Setup
program, or no operating
system on hard drive.
Faulty system board.
PCIe device BIOS (Option
ROM) checksum failure
detected during shadowing.
Cables to expansion card(s)
loose; faulty or improperly
installed expansion card(s).
Faulty or improperly
installed PCIe card in
the specified slot.
Error encountered in
initializing PCIe device;
faulty system board.
About Your System
manuals search engine
Corrective Actions
Check the hard-drive
configuration settings in the
System Setup program.
See "Using the System Setup
Program and UEFI Boot
Manager" on page 57.
If necessary, install the
operating system on your
hard drive. See your
operating system
documentation.
See "Getting Help" on
page 177.
Reseat the expansion card(s).
Ensure that all appropriate
cables are securely connected
to the expansion card(s).
If the problem persists,
see "Troubleshooting
Expansion Cards" on
page 162.
Reseat the PCIe card in the
specified slot number.
See "Troubleshooting
Expansion Cards" on
page 162. If the problem
persists, see "Getting Help"
on page 177.
Install the NVRAM_CLR
jumper in the clear position
(pins 1 and 3) and reboot the
system. See Figure 6-1 for
jumper location. If the
problem persists,
see "Troubleshooting
Expansion Cards" on
page 162.