Dell PowerEdge T310 Hardware Owner's Manual page 143

1 Turn off the system, including any attached peripherals, and disconnect
2 Open the system. See "Opening the System" on page 85.
3 Remove the expansion card stabilizer. See "Removing the Expansion Card
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
5 Disconnect all the cables from the system board.
6 If applicable, remove all expansion cards and any attached cables.
7 If applicable, remove the iDRAC6 Express card. See "Removing an
8 If applicable, remove the iDRAC6 Enterprise card. See "Removing an
9 If required, disconnect the cables from the SAS backplane.
10 Remove all the memory modules and memory blanks. See "Removing
11 Remove the system fan. See "Removing the System Fan" on page 106.
12 Remove the heat sink and processor. See "Removing a Processor" on
13 Carefully route any loose cables away from the edges of the system board.
14 To remove the system board, using a Phillips screwdriver, remove all the
15 While holding the two touch points on the system board, slide the system
16 Lift the system board away from the chassis.
Downloaded from www.Manualslib.com
the system from the electrical outlet and peripherals.
Stabilizer" on page 87.
page 88.
See "Removing an Expansion Card" on page 118.
iDRAC6 Express Card (Optional)" on page 120.
iDRAC6 Enterprise Card" on page 123.
Memory Modules" on page 113.
NOTE:
To ensure proper reinstallation of memory modules, record the
memory module socket locations.
WARNING:
The heat sink can get hot during operation. To avoid burns, ensure
that the system has sufficient time to cool before removing the system board.
page 126.
screws on the board. See Figure 3-30.
board toward the front of the system. See Figure 3-30.
manuals search engine
Installing System Components
143