If Paper Jams; Misfeed Location Indicators; Cautions - Kyocera Mita KM-C830 Operation Manual

2. If paper jams

If a paper misfeed occurs, copying will stop. A message will appear about the misfeed and the location of the misfeed will be indicated on the
operation panel. Leave the main switch ON ( | ) and refer to "(3) Removal procedures" on page 9-5 to remove the jammed paper.

(1) Misfeed location indicators

1 Misfeed in the paper feed area (page 9-5)
2 Misfeed in the paper conveyor section (page 9-7)
3 Misfeed in the transfer section (page 9-8)
4 Misfeed in the fixing section (page 9-10)
5 Misfeed inside the left cover or near the copy storage table
(page 9-12)
6 Misfeed in the Duplex Unit (Only in duplex copiers) (page 9-13)
7 Misfeed in the optional SRDF (page 9-14)
8 Misfeed in the optional Document Finisher (page 9-15)
7
4
8
6
5
* Do not reuse misfed paper.
* If paper is torn during removal, be sure to remove any loose scraps
* Once misfed paper has been removed, warm-up will begin, the
* If a misfeed occurs in the optional Document Finisher, it is not
Section 9 TROUBLESHOOTING
2
3
1

(2) Cautions

WARNING
High voltage is present in the charger section. Take
sufficient care when working in this area, as there is
a danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take
sufficient care when working in this area, as there is
a danger of getting burned.
of paper from inside the copier, or they could cause another misfeed
later.
misfeed message will disappear, and the copier will return to the
same settings prior to the misfeed.
necessary to add the misfed copy to the other copies in the
Document Finisher tray, as that copy will be automatically made
again.
9-4