Table of Contents
Advertisement
(3) Machine default settings
The following 15 machine default settings can be changed.
Change any or all of the settings as desired in order to make the most
effective use of your copier.
Default setting
1 Status report print
Prints out a list of all machine default settings.
out
2 Auto drawer
Sets whether the automatic drawer switching
switching ON/OFF
function (page 2-5) will be used or not.
3 Auto shut-off
Sets whether the auto shut-off function (page 6-48)
ON/OFF
will be used or not. The auto shut-off function
automatically turns the main switch OFF if no
operation has been performed on the copier for a
certain period of time.
* If auto shut-off interferes with your copying
4 Special paper
Sets the location (a drawer or the multi-bypass tray)
location
where recycled or special paper will be loaded.
* No.3 and No.4 drawers can only be selected
* Be sure to load the type of paper selected under
Description
operations, turn this function OFF. It is
recommended that you try to set a longer time
interval until auto shut-off engages before you
actually turn it OFF.
when the optional Paper Feeder is installed in
your copier.
"% Type of paper" on page 7-31 in the location
selected here.
Section 7 COPIER MANAGEMENT
Available settings
Factory setting
-----
-----
On / Off
On
On / Off
On
Standard copiers
-----
Bypass /
1 paper [SOURCE 1] –
4 paper [SOURCE 4]
Duplex copiers
Bypass /
2 paper [SOURCE 2] –
4 paper [SOURCE 4]
Reference
page
7-28
7-28
7-28
7-28
7-24
Advertisement
Table of Contents
Troubleshooting
