Kyocera FS FS-9530DN Operation Manual page 61

Message
Finisher
path error
Incorrect slot
Please reinstall
Install MK
Folding tray
paper full
Load cassette #
(paper size)/(paper
type)*
*(paper size) and
(paper type) are
displayed flashing
alternately.
Load MP tray
(paper size)/(paper
type)
*(paper size) and
(paper type) are
displayed flashing
alternately.
Mailbox tray ##
paper full
OPERATION GUIDE
The option document finisher is not installed correctly. Install it correctly.
The hard disk or the network interface card has been installed in the wrong slot.
Turn off the printer and reinstalled in the correct slot.
The maintenance kit (MK-710 for FS-9130DN and FS-9530DN) needs to be
replaced.
Replace the maintenance kit since the total number of printed pages has reached
500,000. Call for service. The maintenance kit includes a drum unit, developer
unit and so on.
The folding tray has become full. You must remove all printed pages from the
folding tray. When the printer senses that the folding tray is empty again, it will
continue printing into the folding tray.
There is data for printing that matches with a paper cassette setting (paper size,
paper type), but there is no paper in the paper cassette.
Set paper into the paper source as indicated by # in the operation panel, and
press [GO] to restart printing. However, the paper source numbers (3 to 4) are
only displayed when there is an option paper feeder installed.
Or, if you want to print from a different paper source press
alternative? (paper size)/(paper type) * and you can change the source for
paper feeding.
After selecting a paper source and pressing [MENU], Paper Handling >
appears. By pressing
setting the correct paper size and type, press [OK] to check the paper source,
and press [GO] to start printing.
There is no paper cassette set (paper size, paper type) that matches with the data
for printing, so printing is done from the MP tray. Set paper into the MP tray that
matches the paper size and type shown on the display and press [GO] to restart
printing.
Or, if you want to print from a different paper source press
alternative? (paper size)/(paper type) * and you can change the source for
paper feeding.
After selecting a paper source and pressing [MENU], Paper Handling >
appears. By pressing
setting the correct paper size and type, press [OK] to check the paper source,
and press [GO] to start printing.
The mailbox tray is full. When removing the paper, printing will be resumed.
## indicates the tray number.
Corrective Action
, the paper size and type settings menu appears. After
, the paper size and type settings menu appears. After
Troubleshooting
or to display Use
or to display Use
4-9