Kyocera FS FS-9530DN Operation Manual page 60

Troubleshooting
Message
Call service
####:0123456
Cassette #
not loaded
Chad box full
Check chad box
Press GO
Clean printer
Press GO
Close finisher
cover
Close
front cover
Close
left cover 1(2,3)
Close mailbox
cover
Duplex disabled
Press GO
Error. Power off
F###
Finisher tray ##
paper full
4-8
#### represents a mechanical error (#=0, 1, 2, ...). Call for service.
The printer does not operate when this message is displayed.
The total number of pages printed is also indicated, e.g.
0123456.
A cassette is not loaded properly in the printer.
Properly load the cassette indicated by #. The number (#) of the cassette is from
1 to 4.
The punch unit chad box of the option document finisher is full. Discard the
chads.
The punch unit waste box of the document finisher is full or is not installed
correctly. Check if the box is properly installed, and then discard the chads if the
box is full. Press [GO] to resume printing.
Clean the inside of the printer. Refer to Toner Container Replacement on page 3-3.
This message will be displayed when replacing the toner container after the
message Replace toner Clean printer is displayed. After cleaning the
inside of the printer, press [GO] and the printer will be ready for printing.
Close the option document finisher cover.
Close the printer front cover.
Close the printer left cover. If left cover of the option paper feeder is open, 2 or 3
is displayed.
Close the mailbox cover.
Duplex printing cannot be performed due to paper size or type. Press [GO] and
the printer will print on one side only.
Turn the power switch off and then back on again. If this message still remains,
turn the power switch off, and contact your service representative or authorized
service center.
The finisher tray is full. When removing the paper, printing will be resumed. ##
indicates the tray number.
Corrective Action
OPERATION GUIDE