–
+
ELEC
3. Remove the flywheel magnet nut and fly-
wheel magnet.
4. Loosen the pulser coil screws, adjust the
pulser coil 2 position, and then tighten
the screws finger tight.
5. Set the flywheel magnet and then check
the gap again and, if necessary, repeat
steps 3–5.
6. Tighten the pulser coil screws and fly-
wheel magnet nut to the specified
torques.
Pulser coil screw:
4 N·m (0.4 kgf·m, 2.9 ft·lb)
Flywheel magnet nut:
160 N·m (16 kgf·m, 116 ft·lb)
Checking the engine start switch
1. Check the engine start switch for continu-
ity. Replace if there is no continuity.
8-17
Electrical systems
Switch
White
Black
position
(W)
(B)
OFF
ON
START
Checking the engine shut-off switch
1. Check the engine shut-off switch for con-
tinuity. Replace if there is no continuity.
Remove the lock
plate a
Install the lock
plate b
Push the button c
Lead color
Red
Pink
Brown
(R)
(P)
(Br)
Lead color
White (W) Black (B)
62Y3A11