Yamaha F50A Service Manual page 225

2. Install the needle bearing into the lower
case to the specified depth.
É
È For USA and Canada
É For worldwide
NOTE:
• Install the needle bearing with the manufac-
ture identification mark b facing upward.
• When using the driver rod, do not strike the
special tool in a manner that will force the
stopper c out of place.
Driver handle 3: YB-06071
Drive shaft needle bearing remover and
installer 4: YB-06063
Drive shaft needle bearing depth stop 5:
YB-34474
Driver rod SL 6: 90890-06602
Needle bearing attachment 7:
90890-06614
Bearing depth plate 8: 90890-06603
Depth d: 132.5–133.0 mm (5.22–5.24 in)
Depth e: 182.5–183.0 mm (7.19–7.21 in)
3. Install the sleeve, original shim(s), and
bearing outer race.
62Y3A11
Drive shaft and lower case (F50/F50A)
CAUTION:
Add or remove shims, if necessary, when
replacing the pinion or lower case.
NOTE:
• Apply gear oil to the inside and outside of
the sleeve.
• Install the sleeve with the projection f fac-
ing forward.
Drive shaft taper roller bearing cup installer
9: YB-06110
Bearing outer race attachment 9:
90890-06627
Driver handle 0: YB-06071
Driver rod LS 0: 90890-06606
1
2
3
4
5
6
7
8
I
6-26