Disassembling The Propeller Shaft Assembly; Checking The Propeller Shaft Housing - Yamaha F50A Service Manual

NOTE:
Install the bearing separator 2 between the
reverse gear and thrust washer completely,
then the other special service tools.
2. Remove the ball bearing.
È For USA and Canada
É For worldwide
Slide hammer and adapters 7: YB-06096
Stopper guide plate 8: 90890-06501
Stopper guide stand 9: 90890-06538
Bearing puller 0: 90890-06535
Bearing puller claw 1 A: 90890-06536
3. Remove the oil seals and needle bear-
ing.
62Y3A11
Propeller shaft housing (T50/FT50B, FT50C)
Bearing housing needle bearing remover B:
YB-06153
Needle bearing attachment B:
90890-06612
Driver handle C: YB-06071
Driver rod L3 C: 90890-06652
Disassembling the propeller shaft
assembly
1. Remove the spring 1, and then remove
the cross pin 2, dog clutch 3, slider and
shift plunger.

Checking the propeller shaft housing

1. Clean the propeller shaft housing using a
soft brush and cleaning solvent, and then
check it for cracks. Replace if necessary.
1
2
3
4
5
6
7
8
I
6-54