Yamaha F50A Service Manual page 255

È For USA and Canada
É For worldwide
NOTE:
• Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
• When using the driver rod, do not strike the
special tool in a manner that will force the
stopper b out of place.
Driver handle 1: YB-06071
Bearing housing needle bearing remover 2:
YB-06153
Driver rod SS 3: 90890-06604
Needle bearing attachment 4:
90890-06612
Bearing depth plate 5: 90890-06603
Depth c: 25.0–25.5 mm (0.98–1.00 in)
2. Apply grease to the new oil seals, and
then install them into the propeller shaft
housing to the specified depth.
62Y3A11
Propeller shaft housing (T50/FT50B, FT50C)
È For USA and Canada
É For worldwide
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
Bearing housing oil seal installer 6:
YB-06269
Driver handle 7: YB-06071
Ball bearing attachment 8: 90890-06655
Driver rod LS 9: 90890-06606
Depth d: 4.5–5.5 mm (0.18–0.22 in)
3. Install the thrust washer 0 and ball bear-
ing A to the reverse gear B using a
press.
È For USA and Canada
É For worldwide
1
2
3
4
5
6
7
8
I
6-56