Connecting To A Macintosh; Viewing Images On A Macintosh Computer - Kyocera Finecam SL400R Instruction Manual

Connecting to a Macintosh

Viewing images on a Macintosh computer

• You do not need to install the USB drivers on a Macintosh computer. Connect the USB
cable without installing any drivers.
• To view images on your Macintosh, you must have image-viewing software already
installed. (To play movies, QuickTime 4.1 or later must be installed.)
• To view movies that have a large number of pixels or a high frame rate, first copy the
movie to your PC and then play the copy of the movie. If you use your PC to play back a
2
movie that is stored on a memory card loaded in the camera, the data transfer rate may be
too slow for the movie to play smoothly.
1
Load the memory card into the
camera. (
• You cannot check images on your Macintosh unless there is a memory card in the camera.
2
Connect the AC adapter to the
camera.
3
Connect the camera to your
Macintosh using the dedicated USB
cable and then start up the
Macintosh.
• Check the size of the USB connectors. The small
connector plugs into the camera and the large
connector plugs into the USB port on your
Macintosh.
2-20
p.1-3)