Download Print this page

Before Use - Sharp DW-D20A Operation Manual

Dehumidifier sharp dw-d20a
Hide thumbs

Advertisement

BEFORE USE

WHEN USING FOR THE FIRST TIME
There might be some water left in the water tank from the factory product inspection. This
is not a malfunction.
1
Packaging
material
220V power
2
supply
INSTALLATION LOCATION
Avoid places with direct sunlight.
May cause deformation or safety
device activation.
If there is a noise in TV/radio or
radio clock does not display the
correct time, move the product
away as far as possible.
Level, stable place
Thick carpet or futon is a very
unstable place.
Operate it in a room with
temperature from 3°C to 38°C.
The compressor will stop and will not
dehumidify when the room temperature is
lower than 3°C or higher than 38°C.
(Switch to air flow mode)
The compressor safety
device will activate and stop.
40
Room temp. of
20
approx. 3°C-38°C
10
5
0
To prevent the water in the
tank from freezing, the
compressor will stop the
operation.
10
Take out the product
Always hold the knob and take
out from the box.
from the box
Keep the box and packaging
materials for future product
storage.
The louver will automatically
move and close.
Place it on a level,
stable place and
insert the power plug
into outlet
Upper 50cm
or more
Front 50cm
or more
Do not use in the following places
With a lot of salt such as seaside area.
With a lot of machine oil.
With a lot of sulfide gas such as
With a lot of steam or oily
hot-spring area.
smokes.
Do not use any cosmetic products
formulated with fluororesin or
silicone near the dehumidifier.
Plasmacluster ion may not generate if fluororesin or silicone gets into
the main unit.
Hair care products (hair coating solution, hair mousse, hair treatment),
cosmetic products, antiperspirant, antistatic products, waterproof spray,
waxing products, glass cleaner, chemical cloth, wax, etc.
WHAT YOU NEED TO KNOW
When moving
1
Knob (both sides)
2
Defrosting
When the room temperature falls below 15°C, the unit will automatically start defrosting in order to prevent frost
from forming inside the main unit.
Once every 45 minutes, the compressor will stop and "HIGH" air flow mode will operate (for about 12 minutes).
The lower the room temperature, the longer the compressor stop time.
The compressor will stop and will not dehumidify during defrost, and water will not be collected in the tank.
Auto Off function
Behind 20cm
The operation will stop automatically
or more
after 12 hours in case the unit has
been forgotten to be turned off.
(The OFF TIMER "6h" indicator
Sides 20cm
light blinks)
or more
Start
After 12 hours
operating
To operate again, press the STOP button to
release the blinking indicator light.
It will take about 3 minutes to start
dehumidifying again for re-operation.
In order to protect the unit, the compressor will not operate for 3
minutes immediately after plugging in the power plug or stopping
(QUICK/ECO/CONTINUOUS) laundry drying/dehumidifying opera-
tion. Air flow mode will operate and the unit will not dehumidify.
CAUTION
Lift up the main unit and move on easily scratched
floors like tatami, rough places and thick carpets.
[Otherwise, the surface of floor or carpet may be damaged.]
Stop the operation
and dispose water
in the tank
Hold the knob
to move
To cancel the Auto Off function
(For continuous drainage)
The Auto Off function is set when the power plug is plugged in.
Operation stopped
The Auto Off timer will turn off
Blinking
when you press and hold both the
FULL
for 5
OFF TIMER button and STOP
Beep
seconds
Stop
button for 3 seconds.
operating
Once the power plug is pulled, the
Auto Off function will be set again.
Press and hold both OFF TIMER
button and STOP button for 3
Press both for 3 seconds
seconds to restart the Auto off
function.
Air flow operation for
about 3 minutes
Bundle the power cord and hold
along with the knob to move.
Pulling on the power cord will
damage the cord.
Caster
11

Hide quick links:

Advertisement

loading

  Related Manuals for Sharp DW-D20A