Table of Contents
Advertisement
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
on the LED Readout. To select a different DMX address, hit the
<ENTER> button and use the <UP/DOWN> buttons to select the
correct address, then hit <ENTER> to confirm.
Auto, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user
selectable speeds.
1.) To use the fixture in 3 channel or 6 channel mode, use the
<MENU> and <UP/DOWN> buttons to select
<ENTER> button. Then use the <UP/DOWN> buttons to select
either
2.) To set the fixture in automatic mode, use the <MENU> and <UP/
DOWN> buttons to select
DOWN> buttons to select
<UP/DOWN> buttons to select
3.) To use the fixture as either a master or slave unit, use the
<MENU> and <UP/DOWN> buttons to select
<ENTER> button. Then select either
slave. Press the <ENTER> button to confirm.
4.) To adjust the speed of the chase navigate to
and select
button to confirm.
Sound Acitve Mode:
1.) To use this fixture in sound active mode, select
the <ENTER> button. Then select
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture. These settings are
global, they will effect all modes.
1.) use the <MENU> and <UP/DOWN> buttons to select
hit the <ENTER> button.
2.) Then use the <UP/DOWN> buttons to scroll to either
(red),
the maximum level for each color between 0-255 (0=off), then hit
<ENTER> to confirm.
ProPAR Seven.3 Manual Rev. B
3CH or 6CH.
Press the <ENTER> button to confirm.
SP 1
(slowest) to
GREE
(green), or
SHND,
hit <ENTER>. Then use the <UP/
COLO
and hit <ENTER>. Then use the
AUTO
, and press <ENTER>.
NAST
SP 8
(fastest). Press the <ENTER>
SOUN
and hit enter.
BLUE
(blue), and press <ENTER>. Select
Page 12
ADDR
CHND
and hit the
SLND
and then hit the
SLAU
for master or
FADE,
hit <ENTER>,
SHND
, then press
NANU
RED
Copyright (c) 2013 Blizzard Lighting, LLC
for
and
Advertisement
Table of Contents
