Table of Contents
Advertisement
DMX Mode
Allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with
DMX, please read the DMX Primer on page #16.
The COBZilla™ COB RGB 5X5 Pixel Matrix is capable of operating
with 3, 5, or 75 DMX channels. To select the channel mode that you desire,
1:) Press the <MODE> button to select
Readout.
2:) Then press the <SETUP> button to select channel mode,
Auto, Master/Slave, Sound Active & Static Color Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
1.) To set the fixture to one of the Built-in Programs,
select
program by using the <UP> and <DOWN> buttons
2.) To set the program and Strobe setting, select
3:) To use Auto Mode, Press the <MODE> button to reach
AUTO times: 001-100.
4:) To set the program speed and Strobe setting,
Master/Slave Mode:
1:) Each fixture is a master by default. To set the fixture as a slave, use the
<MODE> button to reach
2.) Press the <MODE> button to exit out of the menu.
Sound Active Mode:
1.) To use sound active mode, select
2.) Press the <SETUP> button to change the
<UP> and <DOWN> buttons.
3.) Press the <MODE> button to exit sound trigger mode.
Color Static Mode:
1.) Press the <MODE> button to reach
2:) Then press the <SETUP> button to set the color
3.) Press the <MODE> button to exit static color mode.
CobZilla™ COB RGB 5X5 Pixel Matrix Manual Rev. A
channels: 03, 05, 75 CHs
RUN PROGRAM: 01-19
using the <SETUP> button then the <UP> and <DOWN> buttons to
choose desired program/strobe function. Press the <MODE> button to
switch between settings.
Use the <UP> and <DOWN> buttons
to choose desired program
select
SP: 001-100 FS: 000-100
<UP> and <DOWN> buttons to choose desired program/strobe function.
Press the <MODE> button to switch between settings.
By using the <UP> and <DOWN> buttons, this allows you to
change each value. (000-255)
DMX address: 001
. Use the <UP> or <DOWN> to select desired channel.
using the <MODE> button. Select desired
SP: 001-100 FS: 000-100
using the <SETUP> button then the
SLAVE MODE
======================
SOUND TRIGGER
sensitivity 00-31
STATIC COLOR
R255 G255 B255.
Page 13
on the LED
by pressing <MODE>.
by using the
.
Copyright (c) 2010-14 Blizzard Lighting, LLC
Advertisement
Table of Contents
