Operating Adjustments; Dmx Mode & Dmx Mode Selection; Master/Slave Mode; Sound Active Mode - Blizzard Lighting Puck Fab5 Manual

4. OPERATING ADJUSTMENTS

nOTE: After making any change, the unit will return to the correct mode in about 10 seconds.
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
Readout. Use the <EnTER> button then the <UP> and <DOWn> buttons to
choose a channel between
2.) To change between 3 and 6 channel DMX mode, select
<EnTER>. Select either
confirm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
1.) Use standard DMX cables to daisy chain your units together via the DMX
connector on the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must be
the first unit. Finally, chain the units together using DMX cable.
Master
3.) Select slave function by using the <UP>/<DOWn> keys to reach SLAV in the
Master/Auto menu on the slave units, and they will react in the same as the Master.
Slave
nOTE: When a unit is set to slave and no master is connected,
appear on the LED display.
4.) On the master fixture, use the <UP>/<DOWn> keys to reach
allows you to select the following:
Sound active
Auto mode
Color preset
Color strobe
To set a custom color in Master/Slave/Standalone Mode:
Using this function, you can select any color by adjusting the Red, Green, Blue, Amber and
White values from 0-255. You may also adjust the color balance of the fixture.
Please note that modifying the values in this step will affect ALL modes, therefore
we recommend resetting all levels to their highest value (255) after using this mode.
1.) Select
2.) Choose
confirm.
3.) Using the <UP>/<DOWn> keys, select the color you wish to display by
varying Red/Green/Blue intensity between 0 and 255, then hit <EnTER> to confirm
each color choice.
4.) Select Color preset mode as instructed above, then select
<EnTER> to confirm.
The Puck™ Fab5 User Manual Rev. A
1
and
3Ch, 5Ch
SLNd
SLNd
SoUn
CoLo
CoLo
StCo
NAnu
from the control panel, then hit <EnTER>.
rEd, GrEE bLuE, ANbE or Uhit
,
512
. Press <EnTER> again to confirm.
12Ch
, then press <EnTER> again to
or
NASt
then
SLAu
then
then <EnTER> to confirm.
Auto,
then
CoL 1 - CoL 31,
then
0-255
then
CoL 1 - CoL 31,
then
Page 10
Addr
on the LED
ChNd,
then press
to confirm.
to confirm.
Stby
SHND
then <EnTER> to confirm.
<EnTER>
(Slowest <-.-> Fastest)
<EnTER>
, then hit <EnTER> to
CoL 15.
Copyright (c) 2012 Blizzard Lighting, LLC
will
, which
then