Water Pump - Winnebago View Profile User Manual

NOTE: Ensure the Fresh Water valve is in
NORMAL position to use the water
pump. If the valve is in Tank Fill position,
the pump will run continuously without
delivering water.
Method 2 - Filling the Fresh Water
Tank Through Gravity Fill
-If Equipped
Always fill the fresh water tank at an approved
potable water filling facility or a known purified
drinking water source.
The gravity tank fill tube is located behind a
small, lockable door on the driver or passenger
sidewall toward the back of the coach, depending
on model.
Water Tank Gravity Fill
-Typical View
• Insert hose into fill opening and turn water
supply on. Tank is full when water flows from
the tank vent tube beneath coach and out of the
Gravity Fill door.
Using Tank Water (Gravity Fill)
• Turn Water Pump switch ON. While the
switch is on, the water pump will
automatically supply tank water as needed.

WATER PUMP

When your coach is not connected to a city
water supply, water is supplied from the fresh
water tank by a water system demand pump. A
demand pump is designed to run only when you
are using water. When you open a faucet, the
waterline pressure drops and the pump begins to
run, and it will continue to run as long as the
faucet is open. When you close the faucet, the
line pressure backs up to the pump, and it shuts
itself off.
The pump is self-priming and will run briefly
to build up line pressure when the Water Pump
switch is first turned on. See "Initial Waterline
Priming" for instructions on using the water
system for the first time.
Further Information
Refer to the Water Pump manufacturer's
operation, care, and maintenance information
provided in your InfoCase.
Water Pump Strainer
The pump is equipped with a cleanable
strainer to capture any possible tank-borne
particles that could damage pump components.
NOTE: We recommend that you check and clean
the strainer after each tankful of water
during the first few uses of the Water
Pump system. Thereafter, remember to
check it at least yearly, and be sure to
empty water from it during winterization
procedures.
Water Pump Strainer
-Typical View
To Clean Pump Strainer
• Ensure all Water Pump switches are OFF.
• Twist the inlet cap (bowl) "counter-
clockwise" to unscrew from the strainer
assembly.
SECTION 7 –
PLUMBING
Unscrew bowl
and remove to
clean strainer
7-3