Driving Your Motor Home; Seats - Driver/Co-Pilot; Seat Belts - Winnebago View Profile User Manual

Hide thumbs Also See for View Profile:
Table of Contents

Advertisement

SECTION 3 – DRIVING YOUR MOTOR HOME
The information in this section refers only to
features installed or adapted to the dash and
driver compartment area by Winnebago
®
Industries
. It also includes passenger seating in
the living area of the coach.
Further Information
See the chassis manual in your InfoCase for
all original chassis related controls,
instrumentation, switches, and other features.
This includes items such as cruise control,
climate controls, gauges, wipers, lights, front
seats, and three-point safety belts, etc.
SEATS – DRIVER/CO-PILOT
The driver and co-pilot seats may be
independently adjusted to suit individual
preference.
Further Information
See the chassis manual in your InfoCase for
instructions on seat adjustments.

SEAT BELTS

Seats intended for occupancy while the
vehicle is in motion are equipped with seat belts
for the protection of the driver and passengers.
Lap Belts
The lap belts must be worn as low as possible
and fit snugly across the hip area. Always sit
erect and well back into the seat. To gain full
protection of the safety belt, never let more than
one person use the same safety belt at any one
time, and do not let the safety belts become
damaged by pinching them in the doors or in the
seat mechanism. After any serious accident, any
seat belts which were in use at the time must be
inspected and replaced if necessary.
1- Insert tab into buckle
slot until it "clicks" and is
locked
2- Pull strap to tighten
Adjustment:
To lengthen belt, swivel the tab end at a right
angle to belt and pull strap to desired length. To
shorten, pull loose end of belt.
To Fasten:
Be sure belt is not twisted. Grasp each part of
the belt assembly and push tongue into buckle.
Adjust to a snug fit by pulling the loose end away
from the tongue.
To Release:
Press button in center of buckle and slide
tongue out of buckle.
WARNING
Snug and low belt positions are essential.
This will ensure that the force exerted by
the lap belt in a collision is spread over the
strong hip area and not across the
abdomen, which could result in serious
injury.
Only seats equipped with seat belts are to
be occupied while vehicle is in motion.
Swivel seats must be in the locked,
forward facing position while vehicle is in
motion.
3- Press to
release
3-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents