Power Roof Ventilator - Winnebago View Profile User Manual

Vertical Slider Windows
Vertical windows have spring-loaded catches
on both sides of the window that pop out to hold
the window in its fully raised position. Press the
catches outward toward the frames while
lowering the window.

POWER ROOF VENTILATOR

Lounge, Galley, or Bath Area
–If Equipped
The vent dome is raised and lowered using the
Dome Crank knob on the fan.
The turbine fan will start automatically as the
vent is raised, and stop as the vent is lowered.
Manual Dome
Crank Knob
Power Roof Ventilator
To Operate Ceiling Ventilator
1. Turn the Dome Crank Knob to raise the dome
about 3" or more to allow the turbine fan to
operate. (A built-in safety switch will not let
the fan motor run unless the dome is partially
open).
2. The turbine fan will start automatically as the
vent dome is raised and stop as the vent dome
is lowered and closed. (Fan Power switch
must be ON and Fan Speed knob in a position
other than 0-Off).
3. Turn the Fan Speed knob to the desired level
(0-Off, 1-Low, 2-Med, 3-Hi).
4. Open a window or door to provide airflow.
Direction of airflow is determined by which
window or door is opened.
NOTE: For best results, close all other roof
vents, windows, and doors, then open
one (1) window the farthest distance
from the roof ventilator.The fan speed
selector on the fan allows you to adjust
the amount of circulation you need at any
time.
5. If you want the vent dome raised without the
fan running, turn Off either the Fan Power
switch or Fan Speed knob (0-Off ).
SECTION 12 –
MISCELLANEOUS
Fuse
Fan Speed
Selector
12-7