Generator Hourmeter - Winnebago View Profile User Manual

SECTION 6 –
ELECTRICAL
To use the 120-volt Generator, plug the power
cord into the Generator receptacle within the
utility compartment before starting the
Generator.
Generator
Receptacle
WARNING
Do not plug the power cord into the
generator receptacle while the generator
is running. Electrical shock can cause
personal injury.
Generator Basic Operation
(LP Generator)
NOTE: If the GenSet Start or Stop switch is
momentarily pressed, the monitor panel
will automatically try to start or stop the
generator.
Refer to the manufacturer's user guide
provided in your InfoCase for additional
information.
To Start the Generator
Press and Hold the GenSet Start button until
you hear the Generator running smoothly, then
release.
To Stop the Generator
Press and Hold the GenSet Stop button until
you hear the Generator come to a full stop, then
release.
6-6

Generator Hourmeter

Power Cord
number of hours that the Generator has been
operated. Press the GenSet Meter button once to
get reading.
periodic maintenance is due and to record
services which have been performed.
(Diesel Generator)
To Start the Generator
•
•
LP Generator Start/Stop Buttons
(Located on monitor panel)
-Typical View
The Generator hourmeter registers the total
Refer to the hourmeter to determine when
Generator Hourmeter Button
-Typical View
Generator Basic Operation
Press the Display ON/Gen OFF button once to
wake the Generator.
Once "GEN OFF" appears on the display
screen, press and Hold the Generator Start
button until you hear the Generator running
smoothly, then release.