Link mode
You can change the transmission speed to prioritize
transmission quality or sound quality.
Preparation
If this system is connected to a Bluetooth
disconnect it (
"Disconnecting a device").
1
Press [PLAY MENU] to select "LINK MODE".
2
Press [2, 1] to select "MODE 1" or "MODE 2"
and then press [OK].
• MODE 1
Emphasis on connectivity.
• MODE 2
Emphasis on sound quality.
Note:
The default setting is "MODE 2".
Disconnecting a device
1
Press [PLAY MENU] repeatedly to select
"DISCONNECT?".
2
Press [2, 1] to select "OK? YES" and then
press [OK].
Note:
A device is disconnected when you:
• Select a different source.
• Move the device out of the maximum range.
• Disable the Bluetooth
®
transmission of the device.
• Switch off the system or the device.
Clock and timers
Setting the clock
This is a 12-hour clock.
1
Press [CLOCK/TIMER] to select "CLOCK".
®
device,
2
Within 20 seconds, press [3, 4] to set the time.
3
Press [OK].
Press [CLOCK/TIMER] to show the clock for a few
seconds.
Note:
• Reset the clock regularly to maintain accuracy.
• The clock is reset when there is a power failure or when the
AC power supply cord is removed.
Play timer
Except for Bluetooth
®
source
You can set the timer to come on at a certain time to:
• Wake you up
Preparation
Set the clock.
1
Press [CLOCK/TIMER] to select "
2
Within 10 seconds, press [3, 4] to set the start
time.
3
Press [OK].
4
Do steps 2 and 3 again to set the end time.
5
Press [3, 4] to select the source you want to
play and then press [OK].
To start the timer
1
Prepare the audio source.
Prepare the music source you want to listen to (disc,
USB, radio or external equipment) and set the
volume.
2
Press [PLAY
] to select "
PLAY ON".
"
PLAY ON" is shown.
To cancel, press [PLAY
] again.
The system must be switched off for the timer to
operate.
To check the settings
Press [CLOCK/TIMER] to select "
Note:
• The play timer starts at a low volume and increases
gradually to the preset level.
• The timer comes on at the set time every day if the timer is
on.
PLAY".
PLAY".
11