Clock And Timers - Panasonic SC-HC212 Operating Instructions Manual

Secondary service
You can listen to secondary services when "
1
Press [PLAY MENU] repeatedly to select
"DAB SECONDARY".
2
Press [R, T] to select the secondary service and
then press [OK].
To cancel, select "PRIMARY".
Note:
The setting is cancelled when you select other stations.
Viewing available information
You can view the following information on the display
panel:
Dynamic label
PTY display
Ensemble label
Frequency display
Time display
Press [DISPLAY].
Checking the signal quality
You can check the signal quality when adjusting the
antenna.
1
Press [PLAY MENU] repeatedly to select
"SIGNAL QUALITY".
2
Press [OK].
The frequency block followed by the reception quality
is shown.
To select other frequency blocks, press [R, T].
Frequency Frequency
block
3
Press [OK] again to exit.
Automatic clock adjustment
You can set the clock to update automatically.
1
Press [PLAY MENU] repeatedly to select
"AUTO CLOCK ADJ".
2
Press [R, T] to select "ON ADJUST" and then
press [OK].
To cancel, select "OFF ADJUST".
10
10
" is shown.
Information about the DAB
broadcast
Programme type
The name of the ensemble
The frequency block and
frequency is shown
Current time
Reception quality
0 (poor) to 8 (excellent)

Clock and timers

Setting the clock
This is a 24-hour clock.
1
Press [SETUP] repeatedly to select "CLOCK".
2
Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select "CLOCK" and
then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer switches off the system after the set time.
1
Press [SETUP] repeatedly to select "SLEEP".
2
Press [R, T] to select the setting (in minutes) and
then press [OK].
To cancel, select "OFF".
Note:
•
The remaining time is shown at every minute except when
other operations are being performed.
"SLEEP 1" will always be shown when only 1 minute
remains.
•
The sleep timer always comes first. Be sure not to set an
overlap of timers.
Play timer
You can set the timer to come on at a certain time to wake
you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select "TIMER ADJ".
2
Press [R, T] to set the start time and then press
[OK].
3
Repeat step 2 to set the end time.
4
Press [R, T] to select the music source you want
to play and then press [OK].
To start the timer
1
Press [SETUP] repeatedly to select "TIMER SET".
2
Press [R, T] to select "SET" and then press [OK].
"#" is shown.
To cancel, select "OFF".
The system must be switched off for the timer to
operate.