Clock And Timers - Panasonic SC-PM700 Owner's Manual

Clock and timers

Setting the clock
This is a 12-hour clock.
1
Press [SETUP] repeatedly to select "CLOCK".
2
Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select "CLOCK" and
then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Play timer
(Except for Bluetooth source)
You can set the timer to come on at a certain time to wake
you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select "TIMER ADJ".
2
Press [R, T] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [R, T] to select the source you want to play
and then press [OK].
To start the timer
1
Prepare the source you want to listen to (disc,
USB or radio) and set the volume.
2
Press [SETUP] repeatedly to select "TIMER SET".
3
Press [R, T] to select "SET" and then press [OK].
"#" is shown.
To cancel, select "OFF".
The system must be turned off for the timer to operate.
To check the setting
Press [SETUP] repeatedly to select "TIMER ADJ" and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
•
The timer starts at a low volume and increases gradually to
the preset level.
•
The timer comes on at the set time every day if the timer is
on.
•
If you turn off the system and then turn on again while a
timer is in operation, the timer will not stop at the end time.
Sleep timer
The sleep timer turns off the system after the set time.
1
Press [SETUP] repeatedly to select "SLEEP".
2
Press [R, T] to select the setting (in minutes) and
then press [OK].
To cancel, select "OFF".
Note:
•
The remaining time is shown for a few seconds every
minute. "SLEEP 1" is always shown when only 1 minute
remains.
•
The sleep timer always comes first. Be sure not to set an
overlap of timers.
11