Storage Error Codes - Kyocera FS-C8100DN Operation Manual

Troubleshooting

Storage Error Codes

Hard Disk Errors
Code
01
02
04
05
06
10
85
97
98
99
Memory Card Errors
Code
01
02
04
05
06
RAM Disk Errors
Code
01
02
04
05
06
4-10
Meaning
Hard disk format error. If this error recurs even if the power has been turned off and then
on, reformat the hard disk.
The disk system is not installed. Recheck the requirements for using the system and the
devices.
There is no available hard disk space. Delete unnecessary files, etc., in order to free up
space.
The specified file does not exist in the hard disk.
There is no memory available to the hard disk system. Increase the available memory.
Formatting is not possible because host data is being spooled on the hard disk. Wait until
the hard disk is ready, and then format.
VMB: Alias error. The alias setting was lost, or the virtual tray corresponding to the alias
does not exist. Set the alias again.
The number of permanent code jobs that can be stored reached the limit value, and no
more can be saved. Either delete some unnecessary jobs, etc., or increase the limit.
An unreadable page was found in a job (The job is damaged.).
A print job for the specified ID does not exist in the hard disk.
Meaning
The printer does not support the memory card inserted.
The memory card is not installed.
The memory card is full and cannot hold further data. Purge unnecessary files or use a
new memory card.
The specified file is not on the memory card.
Insufficient printer memory to support the memory card system. Expand printer memory.
Meaning
Format error. Try turning the power off and on again.
RAM disk mode is Off. Turn RAM disk mode On from the operation panel.
No disk space. Purge unnecessary files.
The specified file is not on the disk.
Insufficient printer memory to support the RAM disk system. Expand printer memory.