Kyocera FS-C8100DN Operation Manual page 51

Message
Close
mailbox cover
Close
top cover
Duplex disabled
Press GO
e-MPS not stored
Press GO
Error power off
F###
File not found
Press GO
Finisher
path error
Finisher tray ##
paper full
Folding tray
paper full
Format error
Hard disk
Format error
Memory card
Hard disk err ##
Press GO
I/F occupied
ID error
Incorrect slot
Please reinstall
Insert the same
Memory card
Install MK
[#]
Corrective Action
Close the cover of the optional mail box.
Close the top cover.
You attempted to print with a paper size and paper type that cannot be used for duplex
printing. Press [GO] to print onto one-side of the paper only.
The e-MPS job cannot be stored because the RAM disk is disabled, the RAM disk size is
insufficient, a hard disk is not installed, or the hard disk is full. Press [GO] to print an error
report.
Turn the power switch off and then back on again. If this message still remains, turn the
power switch off, and contact your service representative or authorized service center.
You have attempted to print a job that is not contained in the specified virtual mailbox, or the
specified virtual mailbox is not found.
If Auto Error Clear is set to On, printing will automatically resume after a preset period of time.
The optional document finisher is not installed correctly. Install it correctly.
The finisher tray is full. When removing the paper, printing will be resumed. ## indicates the
tray number.
The folding tray has become full. You must remove all printed pages from the folding tray.
When the printer senses that the folding tray is empty again, it will continue printing into the
folding tray.
The hard disk installed in the printer is not formatted, and therefore cannot be read or written.
To format the hard disk, follow the procedure in the Installation Guide of the hard disk.
The memory card inserted in the printer is not formatted, and therefore cannot be read or
written.
A hard disk error has occurred. Look at the error code given in place of ## and refer to
Storage Error Codes on page 4-10. To ignore the hard disk error, press [GO].
This message is displayed when you attempt to use the printer's operation panel to change
the environmental settings on the interface from which data are presently being received.
The user ID entered for a private job, or a stored job is not correct. Check the user ID that you
specified on the printer driver.
The hard disk or the network interface card has been installed in the wrong slot. Turn off the
printer and reinstall the hard disk or the network interface card in the correct slot.
You have inserted the wrong memory card when the Insert again message was
displayed. Remove the wrong memory card from the printer's memory card slot and insert the
correct memory card. The printer again reads it from the beginning of the data.
Replace the Maintenance Kit A or B which is displayed on the message display. Replacement
of the maintenance kit is necessary at every 300,000 images of printing and requires
professional servicing. # indicates A or B. Contact your service technician.
Troubleshooting
4-7