Kyocera FS 9530DN Advanced Operation Manual page 76

Using the Operation Panel
2-48
Setting the Character Pitch for Courier/Letter Gothic
You can set the character pitch for fixed-pitch fonts when the default font
is Courier or Letter Gothic.
1
Press [MENU].
2
Press or
appears.
3
Press .
4
Press or
5
Check that Internal is displayed and
press .
6
Press or
appears.
7
Press [OK]. A blinking cursor ( _ ) appears.
8
Press or
cursor is blinking. The character pitch can be set between 0.44 and 99.99
characters per inch, in 0.01 character-per-inch increments. You can use
and to move the cursor right and left.
9
When the desired size is displayed, press [OK].
10
Press [MENU]. The message display returns to Ready.
Setting the character code set
You can change the character code set. Available character code sets vary
depending on the current font. (The default character code set is IBM PC-
8.)
1
Press [MENU].
2
Press or
appears.
3
Press .
repeatedly until Font >
repeatedly until >Font Select > appears.
repeatedly until >>Pitch
to increase or decrease the value of the figure where the
repeatedly until Font >
Font
>Font Select
Internal
>>Pitch
10.00 cpi
>>Pitch
10.00 cpi
Font
ADVANCED OPERATION GUIDE
>
>
>