Kyocera FS 9530DN Advanced Operation Manual page 146

Options
Removing Memory Module
Testing the Expanded Memory
4-14
7
When you finish installing the DIMM, mount the memory slot cover and
fasten it with the screw.
To remove a memory module, carefully pull the end clips outwards, then
pull the memory module out of the socket.
After you finish installing DIMMs in the printer, test the printer to see if the
installation was successful. To test the expansion memory, proceed as
follows:
1
Make sure the printer is turned off. Plug the power cord into the printer and
turn the printer on.
2
Press [MENU] on the operation panel.
3
Press or repeatedly until Print Status Page appears.
4
Press [OK] twice.
5
If the installation was successful, the amount of memory shown on the
status page will correspond with the amount of expanded memory. (The
factory installed memory size is 64 MB for FS-9130DN, 128 MB for FS-
9530DN.)
ADVANCED OPERATION GUIDE