Kyocera FS 9530DN Advanced Operation Manual page 66

Using the Operation Panel
2-38
To confirm or change network card parameters, proceed as follows:
1
Press [MENU].
2
Press or repeatedly until Interface > appears. One of the interface
names shown below appears, indicating the current interface.
Parallel
USB
(default)
Network
(only when an optional network interface card is installed)
Option
(only when an optional RS-232C interface card is installed)
Serial
3
Press [OK]. A blinking question mark (?)
appears.
4
Press or repeatedly until Network
appears.
5
Press [OK] again.
6
Press . Each time
below.
If On, print the standard Network Interface
Status Page after the Printer Status Page.
Refer to page 2-20.
If On, print the optional Network Interface
Status Page after the Printer Status Page.
Refer to page 2-20.
or is pressed, the display changes as shown
ADVANCED OPERATION GUIDE
Interface
?Parallel
Interface
?Network
>NetWare
Off
>TCP/IP
Off
>AppleTalk
Off
>Network Status
Page Off
>Opt. StatusPage
On