Related Manuals for Citronic 170.840UK
Summary of Contents for Citronic 170.840UK
- Page 1 CSP & CSL-SERIES MIXING CONSOLES Item ref: 170.840UK, 170.842UK, 170.844UK, 170.850UK, 170.852UK, 170.854UK User Manual...
- Page 2 Caution: Please read this manual carefully before operating Damage caused by misuse is not covered by the warranty Introduction Thank you for choosing a CSP/CSL mixing console as part of your professional sound system. This product has been developed to provide a wide range of facilities for professional and reliable sound reinforcement. Please read and keep this manual to achieve the best results from your purchase and avoid damage through misuse.
-
Page 3: Console Layout
Console layout Each CSP/CSL mixing console has comprehensive input and output sections which can be split further into various stages of processing and routing. All preamps have studio grade, low noise architecture for the cleanest possible path throughout the signal chain. The input stages are repeated across each channel of the console, which simplifies operation and enables quick and easy location of various controls. - Page 4 Mic/Line Input Section Channel inputs and inserts are provided as XLR and/or 6.3mm jack sockets. The connections for these inputs are assigned as follows. MIC input Connect a balanced microphone to this XLRF input. An unbalanced microphone can be connected provided that +48V phantom power is not used.
-
Page 5: Channel Routing
EQ Section HIGH This control can boost or cut the high frequencies (centre 12kHz) by ±15dB (12 o’clock position is zero) This control can boost or cut the mid frequencies (centre 2.5kHz) by ±15dB (12 o’clock position is zero) This control can boost or cut the low frequencies (centre 80Hz) by ±15dB (12 o’clock position is zero) Channel Routing 9. -
Page 6: Graphic Equalizer
Graphic Equalizer The main EQ is a stereo 7-band graphic equalizer, offering refined audio spectrum shaping and feedback control for live mic situations. 15. EQ sliders. Each slider controls a boost or cut of up to 12dB centred at the specified frequency. DSP Effects Engine CSP and CSL series mixers each have an internal 24-bit DSP processor for audio effects, as detailed on the DSP Table (on the following page) - Page 7 CSP & CSL-series User Manual...
-
Page 8: Master Output Section
Master Output Section 20. 2 TRACK INPUT Left + Right RCA connection for auxiliary input of a playback device (e.g. CD or mp3) governed by the 2TK IN LEVEL rotary control 21. 2 TRACK OUT Left + Right RCA connection for main mix output to a recording device. -
Page 9: Rear Panel
Rear Panel 36. Speaker outs (CSP only) Left & Right twist-lock SPK connectors for speaker connection (4Ω min.) 37. Cooling fan vent (CSP only) Ventilation for internal cooling fan. Do not obstruct or cover. 38. Power switch Illuminated rocker switch for main power on/off 39. -
Page 10: Specifications
Specifications Model CSP-408 CSL-8 CSP410 CSP714 Power supply 230Vac, 50/60Hz (IEC) Fuse rating T10A T10A T15A Power consumption (max) 600W 600W 1000W Output power RMS @ 4Ω 2 x 200W 2 x 200W 2 x 350W Output power RMS @ 8Ω 2 x 130W 2 x 130W 2 x 230W... -
Page 11: Troubleshooting
Troubleshooting Ensure mains outlet voltage is correct for the unit Use power lead supplied with the unit and check condition is OK No power “ON” LED on control panel Check power is switched on at the rear panel Check IEC fuse – if blowing fuses, refer to qualified service personnel Check input signals and condition of connection leads Check GAIN is not too low on channel input(s) Check channel fader, GAIN and EQ controls are not turned fully down... - Page 12 Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life. The goods must be disposed of according to your local council guidelines. Errors and omissions excepted.
Need help?
Do you have a question about the 170.840UK and is the answer not in the manual?
Questions and answers