Advertisement
Description:
When ALARMS are set and reached, the Pellet Boss ® will
sound a LOUD beep, and the appropriate display screen will flash. The
alarm is programmed to sound for (10) ten minutes before it automatically
shuts off.
?
Settings:
To end an active alarm, push any button on the Pellet Boss ®
control panel. To entirely shut off ALL audible ALARMS on the Pellet
Boss:
?
Push the UP ARROW button for (10) ten seconds until MAKGRILL Ver.
2.0 (or higher) is displayed.
?
Press the RIGHT ARROW button until you reach ALARM ENABLED.
?
Press the STAR button.
?
Use the UP or DOWN arrow button to select either ENABLED or
SILENT. Press the STAR button to accept.
?
Press and hold the UP ARROW button for (3) seconds to exit. The
screen reverts back to the SETPOINT temperature.
Description:
Manual Mode is designed as a back-up in case there is a
thermocouple failure. If your thermocouple stops working, the grill will not
be able to detect the actual grill temperature. Therefore, your MAK GRILL
will not function properly. In this case, the MANUAL MODE will allow you
to use your grill until you receive and install a replacement thermocouple.
Settings:
To enable the MANUAL MODE, press and hold the STAR
button unit MANUAL SMOKE is displayed. Press the STAR button again.
The word SMOKE will begin flashing. Use the UP or DOWN ARROW
buttons to select from SMOKE (175 degrees), LOW (225 degrees),
MEDIUM (275 degrees), MEDHIGH (350 degrees) or HIGH (450+
degrees). Press the STAR button again to set your selected cooking
temperature. The setting selected will stop flashing and the grill will adjust
to the new set temperature. Note: Because there is no working
thermocouple, the screen will not show the grill temperature. To return to
the NORMAL MODE, press and hold the STAR button (3) seconds, or
turn the grill off.
Description:
This screen will display whenever the igniter rod is on.
Once the igniter has turned off, the screen will display the grill
temperature. The screen will also activate whenever the "auto relight
sequence" which initiates if the fire in the firepot has gone out. IGNITING
will show on the display screen, and the grill will repeat the lighting
sequence up to (3) three times before the Pellet Boss® shuts off the grill
and displays FLAME OUT, CHECK FIREPOT, CHECK HOPPER.
Settings:
There are no user settings for this feature.
14
ALARMS
MANUAL MODE
IGNITING PELLETS
Advertisement
