APRILIA SPORTCITY ONE 125 Service Station Manual page 131

SPORTCITY ONE 125
Engine
- The correct warm up time depends on the ambient temperature.
- If protrusion, resistance or timing values are different from the ones prescribed, replace the starter.
- Assemble the starter to the carburettor being careful to position the O-Ring correctly, insert the plate
with the machined side contacting the starter, tighten the fixing screws.
- Position the starter as shown in the figure.
- Assemble the protection casing.
NOTE
TO CARRY OUT THIS CHECK PAY SPECIAL ATTENTION NOT TO GENERATE SHORT CIRCUITS
USE A CABLE SECTION WITH A TERMINAL SUITABLE TO BE CONNECTED TO THE STARTER.
Characteristic
Starter pin travel
10 mm (at 24°)
Starter resistance
20 Ohm (at 24°)
Check the automatic starter: Keihin maximum time
5 min
ENG - 131