Top-Up - APRILIA SPORTCITY ONE 125 Service Station Manual

SPORTCITY ONE 125

Top-up

•
Remove the mirror and the pump cov-
er.
CAUTION
TO REMOVE THE TWO SCREWS «1» THAT FIX THE RES-
ERVOIR COVER «2», TURN THE HANDLEBAR SO THAT
THE FLUID INSIDE THE BRAKE FLUID RESERVOIR IS
PARALLEL TO «MIN» REFERENCE MARK. IF THIS PRO-
CEDURE IS NOT CARRIED OUT, THE BRAKE FLUID WILL
SPILL OUT OF THE RESERVOIR.
•
Turn the handlebar so that the fluid in the brake fluid reservoir is parallel to the «MIN» ref-
erence mark.
•
Undo the two screws «1».
•
Remove cover «2».
•
Remove cover guide «4».
WARNING
AVOID PROLONGED AIR EXPOSURE OF THE BRAKE FLUID. BRAKE FLUID IS HYGROSCOPIC
AND ABSORBS MOISTURE WHEN IN CONTACT WITH AIR. LEAVE THE BRAKE FLUID RESER-
VOIR OPEN ONLY FOR THE TIME NEEDED TO COMPLETE THE TOPPING UP PROCEDURE.
CAUTION
TO AVOID SPILLING BRAKE FLUID WHILE TOPPING-UP, KEEP THE FLUID LEVEL IN THE RES-
ERVOIR PARALLEL TO THE RESERVOIR EDGE AND DO NOT SHAKE THE VEHICLE.
•
Remove the gasket «5».
NOTE
TO REACH THE MAXIMUM LEVEL, TOP-UP UNTIL COV-
ERING THE SIGHT GLASS COMPLETELY BUT LEAVE A
5-6 MM (0.20-0.23 IN) MARGIN FROM THE RESERVOIR
EDGE.
CAUTION
DO NOT EXCEED THE ''MAX'' LEVEL REFERENCE MARK
WHEN TOPPING-UP. TOP-UP TO THE ''MAX'' LEVEL REF-
ERENCE MARK ONLY WHEN NEW PADS ARE FITTED.
WARNING
NEVER FILL THE RESERVOIR UP TO THE 'MAX'' LEVEL
REFERENCE MARK IF THE PADS ARE WORN; THIS
WOULD CAUSE THE FLUID TO LEAK OUT FROM THE
RESERVOIR WHEN THE NEW PADS ARE FITTED. USE
RECOMMENDED PRODUCT ONLY. NEVER REUSE OLD
BRAKE FLUID.
Maintenance
MAIN - 37