APRILIA SPORTCITY ONE 125 Service Station Manual page 98

Engine
Minimum admitted diameter bearing A
Ø: 32.440 mm
Minimum admitted diameter bearing B
Ø: 19.950 mm
Inlet cam height
27.512 mm
Outlet cam height
27.212 mm
- Check there is no wear on the cam shaft retaining
plate and its associated groove on the cam shaft.
- If any of the above dimensions are outside the
specified limits, or there are signs of excessive
wear, replace the defective components with new
ones.
Characteristic
Maximum axial clearance admitted
0.42 mm
- Check there are no signs of wear on the auto-
matic valve-lifter cam, or the end-of stroke roller,
or the rubber buffer on the automatic valve-lifter
retaining cover.
- Check that the valve lifting spring has not yielded.
- Replace any defective or worn components.
- Check there are no signs of scoring or wear on
the rocking lever bolt.
Check there are no signs of wear on the pad from
contact with the cam and on the jointed adjustment
plate.
- Measure the internal diameter of each rocking
lever.
-Check that the elastic washer dedicated to the
axle clearance of the rocking levers is not worn. -
ENG - 98
SPORTCITY ONE 125