Table 4: Default Route Preferences - Alcatel-Lucent 7450 ESS OS Configuration Manual

Hide thumbs Also See for 7450 ESS OS:
Table of Contents

Advertisement

Configuration Commands
black-hole — Specifies the route is a black hole route. If the destination address on a packet matches
disallow-igp — This value is valid only for indirect static routes. If set and if none of the defined
tag — Adds a 32-bit integer tag to the static route. The tag is used in route policies to control

Table 4: Default Route Preferences

enable — Static routes can be administratively enabled or disabled. Use the enable parameter to re-
Page 84
parameters), then this static route will be replaced with the newly entered command and unless
specified the respective defaults for preference and metric will be applied.
The ip-addr configured can be either on the network or the access side and is normally at least
one hop away from this node.
this static route, it will be silently discarded.
The black-hole keyword and the next-hop or indirect keywords are mutually exclusive. If an
identical command is entered (with the exception of either the next-hop or indirect parameters),
then this static route will be replaced with the newly entered command, and unless specified, the
respective defaults for preference and metric will be applied.
tunneling mechanisms (RSVP-TE, LDP or IP) qualify as a next-hop, the normal IGP next-hop to
the indirect next-hop address will not be used. If not set then the IGP next-hop to the indirect
next-hop address can be used as the next-hop of the last resort.
distribution of the route into other protocols.
Route Type
Direct attached
Static-route
OSPF Internal routes
IS-IS level 1 internal
IS-IS level 2 internal
OSPF External
IS-IS level 1 external
IS-IS level 2 external
BGP
Default
5
Values
1 — 255
enable a disabled static route. In order to enable a static route, it must be uniquely identified by
the IP address, mask, and any other parameter that is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default
enable
Preference
Configurable
0
No
5
Yes
10
Yes
15
Yes
18
Yes
150
Yes
160
Yes
165
Yes
170
Yes
7450 ESS OS Router Configuration Guide

Advertisement

Table of Contents
loading

Table of Contents