Dodge Caliber Owner's Manual page 48

Refer to "LATCH — Child Seat Anchorage
System (Lower Anchors and Tether for CHil-
dren)".
The belt-positioning booster seat is for children
weighing more than 40 lbs (18 kg), but who are
still too small to fit the vehicle's seat belts
properly. If the child cannot sit with knees bent
over the vehicle's seat cushion while the child's
back is against the seatback, they should use a
belt-positioning booster seat. The child and
Universal Child Seat Position Chart
Age Group
Less than 10 kg (0 to 9 months)
Less than 13 kg (0 to 24 months)
9 to 18 kg (9 to 48 months)
15 to 36 kg (4 to 12 years)
Key of letters used in the table above:
U = Suitable for "universal" category restraints approved for use in this mass group.
X = Seat position not suitable for children in this mass group.
46
PAGE POSITION: 48
belt-positioning booster seat are held in the
vehicle by the lap/shoulder belt.
Automatic-Locking Retractor (ALR)
To operate the switchable retractor, pull the belt
from the retractor until there is enough to allow
you to pass through the child restraint and slide
the latch plate into the buckle. Then pull on the
belt until it is all removed from the retractor.
Allow the belt to return into the retractor, pulling
on the excess webbing to tighten the lap por-
Front Passenger
X
X
X
X
JOB: @ibm2/chry_pdm/CLS_chrysler/GRP_owners/JOB_202748-en-cal-10PM491-126-ENG-AA/DIV_og
tion around the child restraint. Follow the in-
structions of the child restraint manufacture.
NOTE:
To reset this feature you must let all of the
belt webbing return into the retractor. You
will not be able to pull out more webbing
until all of the webbing has been returned
back into the retractor.
Seating Position
Rear Passenger
U
U
U
U
Rear Center
U
U
U
U
pubnum: