Dodge Caliber Owner's Manual page 112

change indicator system is duty cycle based,
which means the engine oil change interval
may fluctuate dependent upon your personal
driving style.
Unless reset, this message will continue to
display each time you turn the ignition switch to
the ON/RUN position. To turn off the message
temporarily, press and release the Trip Odom-
eter button on the instrument cluster. To reset
the oil change indicator system (after perform-
ing the scheduled maintenance), refer to the
following procedure:
1. Turn the ignition switch to the ON posi-
tion. Do not start the engine.
2. Fully depress the accelerator pedal
slowly three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK
position.
NOTE:
If the indicator message illuminates when
you start the vehicle, the oil change indica-
tor system did not reset. If necessary, repeat
this procedure.
110
PAGE POSITION: 112
15. Cruise Indicator — If Equipped
This indicator shows that the
Speed Control system is ON.
16. Trip/Odometer Display Reset Button
Press this button to change the display from
odometer to either of the two trip odometer
settings. Trip A or Trip B will appear when in the
trip odometer mode. Push in and hold the
button for two seconds to reset the trip odom-
eter to 0 miles (0 km). The odometer must be in
Trip mode to reset.
17. Electronic Throttle Control (ETC) Light
This light informs you of a problem
with the Electronic Throttle Control
(ETC) system. If a problem is de-
tected, the light will come on while
the engine is running. Cycle the
ignition key when the vehicle has
completely stopped and the shift lever is
placed in the NEUTRAL position. The light
should turn off. If the light remains lit with the
engine running, your vehicle will usually be
drivable; however, see an authorized dealer for
service as soon as possible. If the light is
flashing when the engine is running, immediate
JOB: @ibm2/chry_pdm/CLS_chrysler/GRP_owners/JOB_202748-en-cal-10PM491-126-ENG-AA/DIV_og
service is required and you may experience
reduced performance, an elevated/rough idle
or engine stall and your vehicle may require
towing. The light will come on when the ignition
is first turned ON and remain on briefly as a
bulb check. If the light does not come on during
starting, have the system checked by an au-
thorized dealer.
18. Position Light Indicator — If Equipped
This indicator will illuminate when
the park lights or headlights are
turned on.
19. Electronic Stability Control (ESC) OFF
Indicator Light — If Equipped
This light indicates the Electronic
Stability Control system (ESC) has
been turned off by the driver.
20. Turn Signal Indicators
The arrow will flash with the exterior turn
signal when the turn signal lever is oper-
ated.
pubnum: