To Set The Security Alarm; To Disarm The System; Vehicle Security Alarm Manual Override; Premium Vehicle Security Alarm - If Equipped - Dodge Caliber Owner's Manual

deactivated, the horn will sound again after a
five second delay for another 30 seconds. If the
trigger remains present, this cycle will repeat
for up to five minutes.

To Set the Security Alarm

1. Remove the key from the ignition switch and
get out of the vehicle.
2. Lock the door using either the power door
LOCK switch or the Remote Keyless Entry
(RKE) transmitter and close all doors.
3. The Vehicle Security Light in the instrument
cluster will flash rapidly for approximately
16 seconds. This shows that the Vehicle Secu-
rity Alarm is arming. During this period, if a door
is opened, the ignition switch is turned ON, or
the power door locks are unlocked in any
manner, the Vehicle Security Alarm will auto-
matically disarm. After approximately 16 sec-
onds, the Vehicle Security Light will flash slowly.
This shows that the Vehicle Security Alarm is
fully armed.

To Disarm the System

Press UNLOCK on the RKE transmitter.
16
PAGE POSITION: 18
Vehicle Security Alarm Manual
Override
The Vehicle Security Alarm will not arm if you
lock the doors using the manual door lock
plunger.
PREMIUM VEHICLE SECURITY
ALARM — IF EQUIPPED
The Premium Vehicle Security Alarm system
monitors the doors, hood latch, liftgate, and
ignition switch for unauthorized operation.
If something triggers the security alarm the
audible alert will sound for 30 seconds and
flash the lights for 60 seconds. If the triggering
device is not deactivated, the audible alert will
sound again after a five-second delay for an-
other 30 seconds. If the trigger remains
present, this cycle will repeat for up to five
minutes.
If the intrusion sensor is enabled, the security
alarm will trigger the audible alert for 29 sec-
onds. When this portion of the alarm is set,
movement inside the vehicle will trigger the
Vehicle Security Alarm.
JOB: @ibm2/chry_pdm/CLS_chrysler/GRP_owners/JOB_202748-en-cal-10PM491-126-ENG-AA/DIV_og

To Arm the System

1. Remove the key from the ignition switch and
get out of the vehicle.
2. Lock the door using either the power door
lock switch, or the Remote Keyless Entry (RKE)
transmitter and close all doors.
3. The Vehicle Security Light in the instrument
cluster will flash rapidly for 16 seconds. This
shows that the security alarm is pre-arming.
After 16 seconds the locks will activate and the
Vehicle Security Light will continue to flash
slowly. This shows that the Vehicle Security
Alarm system is fully armed.
Vehicles equipped with the Sentry Key Immo-
bilizer system can be safely started with a valid
key. A valid key is one that is programmed to
that particular vehicle. A valid key will disarm
the Vehicle Security Alarm, an invalid key will
allow the engine to run for two seconds then
stop.
pubnum: