To Disarm The System; Vehicle Security Alarm Manual Override; Remote Keyless Entry (Rke); To Unlock The Doors And Liftgate - Dodge Caliber Owner's Manual

NOTE:
The intrusion sensor (motion detector) ac-
tively monitors your vehicle every time you
arm the security alarm. If you prefer, you can
turn off the intrusion sensor when arming
the security alarm.
To disable the intrusion sensor, activate the
LOCK request three times using the RKE trans-
mitter during the pre-arming period (lamp flash-
ing quickly). The intrusion sensor will automati-
cally be enabled the next time the security
alarm is set.

To Disarm the System

1. Press UNLOCK on the RKE transmitter.
2. Starting the vehicle with a valid Sentry Key
will disarm the security alarm. A valid key is one
that is programmed to that particular vehicle. A
valid key will disarm the security alarm, an
invalid key will allow the engine to run for two
seconds then stop.
NOTE:
• Battery disconnects will not disarm the
security alarm system.
PAGE POSITION: 19
• Using the key in the door lock cylinder
will only unlock the deadbolt locks.
• Once the security alarm is set and the
locks are activated, the only way to open
the doors is with the unlock button on the
RKE transmitter, using the Sentry Key in
the ignition switch, or using the key in the
door lock cylinder. This feature deacti-
vates the door lock plungers and door
handles.
If the security alarm has been triggered, the
Vehicle Security Light will flash twice every two
seconds.
Vehicle Security Alarm Manual
Override
The security alarm will not arm if you lock the
doors using the manual door lock plunger.

REMOTE KEYLESS ENTRY (RKE)

This system allows you to lock or unlock the
doors and liftgate from distances up to approxi-
mately 33 ft (10 m) using a hand-held Remote
Keyless Entry (RKE) transmitter. The RKE trans-
mitter does not need to be pointed at the
vehicle to activate the system.
JOB: @ibm2/chry_pdm/CLS_chrysler/GRP_owners/JOB_202748-en-cal-10PM491-126-ENG-AA/DIV_og
RKE Transmitter with Integrated Key
NOTE:
The line of transmission must not be
blocked with metal objects.

To Unlock The Doors And Liftgate

Press and release the UNLOCK button on the
RKE transmitter once to unlock the driver's
door, or twice within five seconds to unlock all
doors and liftgate. The turn signal lights will
flash to acknowledge the unlock signal. The
illuminated entry system will also turn on.
17
pubnum: