Dodge Caliber Owner's Manual page 130

NOTE:
The AUTO position performs best for front
seat occupants only.
2. Dial in the tempera-
ture you would like the
system to maintain by
rotating the Tempera-
ture Control knob. Once
the comfort level is se-
lected, the system will
maintain that level auto-
matically
heating system. Should
the desired comfort level require air condition-
ing, the system will automatically make the
adjustment.
You will experience the greatest efficiency by
simply allowing the system to function auto-
matically. Selecting the "O" (OFF) position on
the blower control stops the system completely
and closes the outside air intake.
The recommended setting for maximum com-
fort for the average person is 22°C (72°F);
however, this may vary.
128
PAGE POSITION: 130
NOTE:
• The temperature setting can be adjusted
at anytime without affecting automatic
operation.
• Pressing the Air Conditioning Control
button while in AUTO mode will cause the
LED in the control button to flash three
times and then turn off. This indicates
that the system is in AUTO mode and
requesting the air conditioning is not nec-
essary.
• If your air conditioning performance
using the
seems lower than expected, check the
front of the A/C condenser located in front
of the radiator for an accumulation of dirt
or insects. Clean with a gentle water
spray from behind the radiator and
through the condenser. Fabric front fas-
cia protectors may reduce airflow to the
condenser, reducing air conditioning per-
formance.
JOB: @ibm2/chry_pdm/CLS_chrysler/GRP_owners/JOB_202748-en-cal-10PM491-126-ENG-AA/DIV_og
Blower Control
For full automatic opera-
tion or for automatic
blower operation turn the
knob to AUTO position.
In manual mode there
are seven blower speeds
that can be individual se-
lected. In off position the
blower will shut off.
Manual Operation
This system offers a full complement of manual
override features, which consist of Blower Pre-
ferred Automatic, Mode Preferred Automatic, or
Blower and Mode Preferred Automatic. This
means the operator can override the blower,
the mode, or both. There is a manual blower
range for times when the AUTO setting is not
desired. The blower can be set to any fixed
blower speed by rotating the Blower Control
knob (on the left).
NOTE:
Please read the Automatic Temperature
Control Operation Chart that follows for de-
tails.
pubnum: