Dtx Board - Sony HDCU1000 Operation Manual

a CCU POWER indicator
Lights when the power voltage inside the board is normal.
b CAM LOCK (camera lock) indicator
Lights when the transaction with the video camera is
operating normally.
c CAM POWER (camera power) switch
Press downward to turn the video camera connected to this
unit on or off.
d SYSTEM indicators
/1.001 (frame frequency): Lights when the frame
frequency of the camera system is set to 1/1.001.
LINE DELAY (phase difference): Lights when the phase
difference between HD and SD outputs is set to LINE
DELAY.
Phase difference is 90H when the scan line is 1125, or
120H when the scan line is 750.
e 2WIRE CANCEL controls
When using a 2-wire intercom system, adjust the controls
to minimize the side tone level on the producer line
(PROD) and engineer line (ENG).

DTX Board

DTX
CCU
1 OPTICAL CONDITION indicators
CAM
CHARACTER
DISP
2 Menu control switch
OFF
MENU
CANCEL
3 CANCEL/ENTER switch
ENTER
4 +/– switch
a OPTICAL CONDITION indicators
The corresponding LEDs light to show the condition of
optical signal reception at this unit (CCU) and the camera
(CAM):
Green: Good
Yellow: Low optical level
Red: Extremely low optical level, or disconnection
If communication with the connected camera is not
established, all three CAM indicators (green, yellow and
red) go dark.
58
Internal Switches and Internal Boards
b Menu control switch
Displays the setting status of this unit or the setup menu on
the monitor connected to this unit.
DISP: Displays the setting status of this unit.
OFF: Doesnft display the setting status or the setup menu.
MENU: Displays the setup menu.
c CANCEL/ENTER switch
Used for operations on the setup menu. Press towards
ENTER to select an item or to enter a setting, or towards
CANCEL to cancel the setting.
d +/– switch
Used to adjust the setting items on the setup menu.
DRX Board
DRX
1080
720P
SD
PsF
FC
1 Output signal format indicators
60
50
30
25
24
a Output signal format indicators
Displays the format status of the output signal.
1080/720P/SD: One of these indicators corresponding to
the signal status of the SDI OUTPUT 1/2 connectors
of the four SDI signal output from this unit lights.
PsF: Lights when the video camera is operating in
Progressive mode.
FC: Lights when the frame rate converter function of the
unit is performed.
60/50/30/25/24: One of these indicators corresponding to
the field/frame frequency of the output signals lights.