Sony HDCU1000 Operation Manual page 48

h Expansion slots
For installation of an optional HKCU1001 SD Encoder
Unit, HKCU1003 Multi Interface Unit, or HKCU1005
SDI Output Expansion Unit.
For details on installation, contact a Sony service or sales
representative.
i INTERCOM/TALLY/PGM (intercom/tally/
program audio) connector (D-sub 25-pin)
Used for input and output of intercom, tally, and program
audio signals.
Connect to the intercom/tally/program audio connector of
the intercom system.
j MIC REMOTE (microphone remote) connector
(D-sub 15-pin)
Using this connector, the video camerafs microphone
input level may be set by external equipment such as an
audio mixer, in five level (-60, -50, -40, -30, and -20 dB).
When shooting, set the volume to a level appropriate for
the audio conditions.
This connector also outputs a red tally signal and a green
tally signal.
The microphone input level may also be set using the setup
menu. For details on the setup menu, contact a Sony
service or sales representative.
k WF REMOTE (waveform monitor remote)
connector (D-sub 15-pin)
Used to attach to the appropriate connector on a recall-type
waveform monitor when operating the waveform monitor
display using an MSU-900 series Master Setup Unit or an
RCP-700 series Remote Control Panel.
When using a recall-type monitor, preset a display mode
on the waveform monitor, and then recall the mode
externally.
For details on these operations, refer to the Master Setup
Unit or Remote Control Panel manuals.
l TRUNK LINE connector (D-sub 9-pin)
Used to connect to the CCU connector on a video camera
via an RS-232C interface. Used mainly for
communication with equipment on the camera side.
Communication with up to two channels is available.
m I/O PORT connector (D-sub 15-pin)
Used for remote control using an external control device.
Note
Use of a case wider than 42 mm can cause interference at
connectors 2, 4, 5.
It is recommended that you use a JAE-made DA-C1-J10.
48
Locations and Functions of Parts
n WF MODE1, WF MODE2 connectors (4-pin)
Connect to the appropriate connector on a waveform
monitor when monitoring a signal in sequential mode.
A sequence signal will be output when the SEQ button on
the RCP-700 series Remote Control Panel is pressed,
allowing simultaneous monitoring of the R, G, and B
signals in sequential mode.
When both the RCP and MSU are in use, this connector
functions as the output connector for RCP control.
For details on these operations, refer to the Master Setup
Unit or Remote Control Panel manuals.
o RCP/CNU connector (8-pin)
Used to connect to an MSU-900 series Master Setup Unit,
CNU-700 Camera Command Network Unit, or RCP-700
series Remote Control Panel via a CCA-5 Connection
Cable.
Control signals are sent and received via this connector.
When using an RCP-700 series unit, power is also
supplied.
p TRUNK A connector (12-pin)
Used to connect to the CCU connector on a video camera
via an RS-232C or RS-422A interface.
Communication with up to two channels is available.
q MIC1, MIC2 (microphone output 1, 2) connectors
(XLR 3-pin)
Used for output of the microphone signal to the video
camera.
r AC IN (AC power input) connector
Use the specified AC power cord to connect to an AC
power supply.
The AC power cord can be secured to this unit, using the
plug holder (optional).