Pcb Removal And Replacement; Antenna Assembly - KVH Industries TracVision S2 Owner's Manual

Kvh industries satellitetelevision owner's manual installation instructions user's guide technical manual tracvision s2

Table of Contents

A Guide to TracVision S2

When carrying out maintenance

on the PCB, be sure to not drop

any of the small screws inside the

mechanism. If a screw is lost within

the baseplate, it must be retrieved

to avoid causing any damage when

the unit rotates.

5-4

Figure 5-3

5.4.1 PCB Removal and Replacement

Estimated Time to Repair:

The microprocessor PCB assembly is protected by a cover

fastened to the rotating plate –

removed to gain access to the main power fuse and the PCB

assembly.

1. Using needle-nose pliers, remove the E-ring from

one end of the connecting rod –

2. Remove the connecting rod by sliding it off the

bracket.

3. Fully retract the elevation axis motor shaft

–

Reflector Bracket

⁄

hour

Fig.

5-4.

Wing Screw

and Washer

Fig.

5-1. The cover must be

Fig.

5-2.

LNB Clamp

LNB

Table of Contents