Connecting System Components; Figure; Switchplate Cutout Dimensions; Antenna Baseplate Connectors - KVH Industries TracVision S2 Owner's Manual

A Guide to TracVision S2

Switchplate Cutout Dimensions

Antenna Baseplate Connectors

2-8
2.3
The following sections provide instructions for properly wiring
the antenna unit to the components inside the vehicle.
Locating the Switchplate
Before running cables, you need to determine the location for the
TracVision S2 switchplate.
1. The switchplate should be installed in a dry, flat
2. Once you've decided on a suitable location, create

Figure 2-11

Figure 2-12 shows the antenna unit's baseplate connectors.
Figure 2-13
connectors. Refer to these figures when connecting cables to the
antenna unit and the switchplate.
Figure 2-12

Connecting System Components

location within reach of the cables that will
connect to the antenna unit.
a panel cutout in the mounting surface. Figure 2-11
illustrates the mounting dimensions and a full-size
template has been provided in
connecting cables will be routed through this
cutout.
2.35"
on the following page shows the switchplate's
RF2 Data/Power
Appendix C. All
1.85"
RF1