KVH Industries TracVision R5 Owner's Manual page 31

A Guide to TracVision R5/R4
2-20
3. Type @DEBUGON
4. Type the following command (see the Key below)
then press Enter.
@SATCONFIG,X,N,F,S,C,ID,P,B,D
Key: @SATCONFIG = directs data to the RF Board
X = satellite location A or B
N = satellite table # (98 & 99 are slots for user-
F = frequency in MHz (either 00000 or a range from
S = the satellite transponder symbol rate in
C = the FEC code (e.g., 12, 23, 34, 56, 67, 78)
ID = the satellite network ID in hexadecimal format
P = the LNB polarization (v = vertical,
B = the LNB down conversion frequency (l = low,
D = decoding type (0 = test, 1 = DSS-A,
This information has to be entered for each of the following
polarizations:
• vertical high
• horizontal high
or
• right
then press Enter.
configured satellites)
10700 - 12700)
Mbit/second (01000 - 29999)
(0x####)
h = horizontal, r = right, l = left)
h = high, u = USA)
2 = DSS-B, 3 = DVB)
• vertical low
• horizontal low
• left