Wire The Receiver - KVH Industries TracVision M3-ST Installation Manual

7

Wire the Receiver

1. Connect the antenna cable (A) to the "To KVH
Antenna" jack. Do not kink/stress the cable.
2. Connect the RF converter cable (B) to the "RF
Remote Input" jack.
3. Connect the receiver to the TV's video input.
Choose one of the following options:
Option 1 - RCA-type A/V jack (cable included)
Option 2 - S-Video jack
If the TV has only a coaxial input, you will need an
RF modulator (Radio Shack model 15-2526 or
equivalent).
4. Connect the receiver to the TV's audio input.
Choose one of the following options:
Option 1 - RCA-type A/V jacks (cables included)
Option 2 - Digital audio jack
5. Tighten all connections and leave enough slack in
the cables (service loop) for easy serviceability,
allowing you to access the receiver's rear panel.
For details on connecting any additional receivers,
please see Appendix A in the Receiver User's Guide.
Deck
54-0274-01 Rev. C
8
Do not shorten or extend
the antenna cable. Since the
antenna cable carries data,
power, and communications,
the integrity of this cable
and its connections is very
important.
Be sure to route cables with-
in the vessel appropriately to
avoid damage. For example,
do not route any cables
through wet areas (bilges) or
near hot exhaust pipes.
Antenna
© 2006 KVH Industries, Inc., All rights reserved.