KVH Industries TracVision L3 Owner's Manual page 70

A Guide to TracVision L3/S3
Operational Commands
Tracking and Conical
Scan Commands
E-4
E.3
To execute the following commands, first put the antenna unit in
idle mode by typing HALT and pressing "ENTER." After the
system comes to a halt, type DEBUGON and press "ENTER" to
enter programming mode.
Table E-3 Tracking Mode
Function:
Command:
Argument:
Response:
Idle Mode
Function:
Command:
Argument:
Response:
Current Cable Wrap Angle
Function:
Command:
Argument:
Response:
E.4
Table E-4
Target Location
Function:
Command:
Argument:
Response:
Operational Commands
starts active tracking of the satellite
TRACK
none
echoes the command
halts active tracking and conical scan, then enters
idle mode
HALT
none
echoes the command
sets or reports current cable wrap angle, defined as
0° (CCW limit) to 700° (CW limit); the value is
expressed as 0000 - 7000 with an implied decimal
WRAPANGLE,xxxx
the desired cable wrap angle setting
Wrap Angle = xxxx
Tracking and Conical
Scan Commands
reports the target location in antenna frame. Data
format is E### for elevation in degrees 000-900 and
A#### for azimuth in degrees 0000-3599 with
implied decimals
TGTLOCATION
none
Target Location = A = E###, A####
B = E###, A####