KVH Industries TracVision L3 Owner's Manual page 29

A Guide to TracVision L3/S3
Satellite Installation Names
Satellite Install Name
North American Satellites
º
DSS 101 W DSS_101
º
DSS 119 W DSS_119
º
EchoStar 61 W Echo_61
º
EchoStar 110 W Echo_110
º
EchoStar 119 W Echo_119
º
EchoStar 148 W Echo_148
ExpressVu Expressvu
European Satellites
º
ASTRA1 19.2 E ASTRA1
º
ASTRA2N 28.2 E ASTRA2N
º
ASTRA2S 28.2 E ASTRA2S
º
Hispasat 30.0 W HISPASAT
º
Hotbird 13.0 E HOTBIRD
º
Sirius 5.0 E SIRIUS
º
Thor 0.8 W THOR
Other Installation Designations
User-defined 1 USER1*
User-defined 2 USER2*
None None
* USER1 and USER2 will only be
available if one or two user-defined
satellites have been added to the
library as detailed in Section 2.5.2,
"Programming User-defined Satellites."
2-18
3. Apply power to the TracVision L3/S3 system and
allow the system to complete full initialization.
Data should be scrolling on the PC display to
identify any system problems detected. If no data
is seen, recheck your connections and the terminal
software setup.
Installing the Satellite of Choice
Once the data connection has been made between the PC and the
Table 2-5
TracVision L3/S3, you must assign the satellites you wish to have
in the satellite pair. On the maintenance screen, put the antenna
in Idle Mode by typing HALT, then enter the SATINSTALL
command:
Command:
Where:
Table 2-5 lists the assigned names for satellites that are in the
preprogrammed North American and European satellite library.
If you do not wish to assign a pair of satellites, enter None as the
name of Satellite B.
After you have assigned satellites as Satellites A and B, the final
step is to tell the antenna which of the two satellites it should
acquire and track. This step should be carried out the first time a
satellite is selected, allowing the system to carry out the initial
download of the channel guide. To do so, enter the Satellite
Selection parser command as follows:
Command:
Where:
Choosing A or B will assign the antenna to acquire and track that
installed satellite. To complete the process, type ZAP<cr> to
restart the system. Be sure the IRD satellite configuration matches
your chosen TracVision L3/S3 settings.
SATINSTALL,<sat_a_name>,<sat_b_name><cr>
(<cr> indicates a carriage return/ENTER key)
<sat_a_name> = the name of your choice for
Satellite A
<sat_b_name> = the name of your choice for
Satellite B
@L,x<cr>
x = A or B (one of your selected satellites as
defined during the SATINSTALL process)